Sunday 17 March 2013

Splat!!!

Introduction

Recently, I was asked where I obtained my "splat" markers.  These can be seen in many of my battle reports, especially for All Things Zombie (ATZ).  The picture above comes from one such game; each marker shows where a casualty has occurred.  From the pattern that builds up it's easy to see where the hottest action has occurred!

Well, the splat markers are home-made, so you cannot buy them.  The good news is that they're really cheap, very easy to make and take only a few seconds each to paint.  Here's how I do it:

Making the tokens

I bought my counters from EM-4, though I'm sure that other suppliers of "game accessories" will have similar products.  At the time of writing, a pack of 12mm clear counters costs £1.02; each pack holds 50 of the disks.

For the splats, I use a bright scarlet acrylic paint that has been on my bench for years.  Indeed, it's become a bit too thick for most purposes, but works just fine for this.  If you want a less cartoon-like appearance then perhaps a darker red might be more appropriate.  Also note that I don't use my best paintbrushes for this project!

Paint goes on in 4 simple steps.  Once you know what to do, it only takes 10 or 20 seconds to finish each token.  So:

Paint a dot in the centre of each counter.  I make my initial red circles about 1/3 of the diameter of the whole token.

Put some slightly smaller dots around the edge.  I use between 3 and 5 typically.  Don't space them out evenly; a bit of randomness is good here.

Join the "edge dots" to the centre.  Again, try not to have geometrically-precise lines.

Place 3 to 5 much smaller dots around the rim, in the gaps between the "edge dots".  Connect these to the centre with a dotted or dashed line (everything radiates out from the centre of the counter).

Leave to dry.  You're done!

The finished markers can be used to indicate the position of bodies.  This is especially useful in a game with a high casualty rate where you don't have enough models of dead people!  They can also be used as wound markers if your game has units which can take multiple hits.






15 comments:

  1. Cool stuff mate, I do like these markers

    ReplyDelete
    Replies
    1. They're very light-hearted, but they do the job :-) .

      Delete
  2. I honestly thought these commercially available counters that you'd bought. I never guessed that they were home-made. I like them a lot and I'm sorely tempted to make a batch for myself. Great work, Hugh!

    ReplyDelete
    Replies
    1. I suspect you're not the only one to think they were commercial products, though as I said they're really easy to produce at home!

      Delete
  3. Brilliant idea, thanks for sharing.

    ReplyDelete
  4. Very cool, might have to have go a this I could do with some generic ones that could be used in various games.

    ReplyDelete
    Replies
    1. I use my tokens as casualty markers or as wound counters, depending on the game. I imagine that you could find other uses as well...

      Delete
  5. They look very good, I've slways assumes that they were bought too.

    ReplyDelete
    Replies
    1. Seems to have been a common assumption. I don't know whether to feel pleased with myself for having produced something that others regard so highly, or a fraud because they're trivially easy :-) !

      Delete
  6. good job there, Thanks for sharing

    ReplyDelete
  7. I could have sworn that you had a tutorial for making these already. Of course I don't remember the steps so I must have imagined it. Thanks for posting.

    ReplyDelete
    Replies
    1. Must have been somewhere else; I've not written about these markers before :-) .

      Delete
  8. These are great Hugh! I'll be getting some of these clear counters at Salute now - thanks for sharing!

    ReplyDelete